What this product is for

This 30W electronic LED driver converts 100-277V AC input to 24V DC constant-voltage output for compatible LED strip and tape light systems. It is intended for installations that need dimming flexibility across common control types.

Use for

Use for 24V DC LED strip lighting, tape light, undercabinet lighting, cove lighting, display lighting, and other low-voltage lighting loads that require a constant-voltage driver. It is suitable where a Class 2 driver and 5-in-1 dimming support help simplify specification and replacement work.

Avoid for

Avoid using this driver with constant-current LED fixtures, loads above 30W, or systems that do not require 24V DC output. Do not use where the connected lighting load or dimming method is not confirmed to be compatible.

Best for

Best for electricians and lighting contractors matching 24V DC tape light loads in residential, retail, hospitality, and light commercial projects. It is also a practical choice when one driver needs to work with multiple dimming methods instead of stocking separate driver types.

Installed in

Typically installed in millwork, cabinets, coves, valances, display cases, and other concealed lighting locations, subject to enclosure and code requirements. The black powder-coated steel enclosure is listed by source material as suitable for outdoor applications, but actual installation suitability depends on location, protection, and local code.

Why this product exists

This driver is designed to power 24V DC LED lighting from a wide 100-277V AC input range while supporting multiple dimming protocols in one unit. That helps reduce driver selection issues on mixed residential and commercial jobs.

As a typical rule of thumb for LED strip systems, contractors often size drivers with some headroom rather than loading them to the full nameplate wattage. Actual performance depends on installation conditions, connected load, dimmer compatibility, layout, and local electrical code.

Compared with similar products

Compared with non-dimmable 24V power supplies, this model adds 5-in-1 dimming support for broader control compatibility. Compared with higher-wattage drivers, this 30W unit is better suited to shorter runs and lower-load strip lighting zones where a smaller Class 2 driver is appropriate.

Specifications

• Product type: Electronic LED driver
• Output type: Constant voltage
• Output voltage: 24V DC
• Maximum wattage: 30W
• Maximum output current: 1.2A
• Input voltage: 100-277V AC, 50/60Hz
• Dimming: 5-in-1 universal dimming
• Supported dimming methods: TRIAC forward phase, reverse phase, 0/1-10V, resistor, PWM
• Class rating: Class 2
• Output frequency: 800Hz
• Efficiency: 87%
• Load regulation: 1%
• Ripple: 5%
• Maximum input current at full load: 0.3A
• Enclosure: Black powder-coated steel
• Lead wire ratings: Input leads 18 AWG 600V; output leads 16 AWG 300V
• Lead temperature rating: 105 degC (221 degF)
• Compliance: UL 8750, UL 1310, CSA C22.2 No. 250.0