What this product is for

This 300W magnetic LED driver converts 120V AC input to 24V DC constant-voltage output for compatible low-voltage lighting systems. It is intended for hardwired LED strip lighting and similar 24V DC loads where magnetic dimming is required.

Use for

Use for 24V DC LED strip runs, cove lighting, under-cabinet lighting, display lighting, and indoor or outdoor low-voltage lighting systems that require a magnetic dimmable driver. It is commonly used where electricians need a hardwired power supply with higher wattage capacity and dimmer compatibility.

Avoid for

Avoid for constant-current LED fixtures, non-lighting loads, motors, or any load that does not specifically require 24V DC constant voltage. Do not use it as a general-purpose power supply, and do not pair it with incompatible dimmers or non-dimmable fixtures.

Best for

Best for larger 24V LED strip installations, indoor/outdoor architectural lighting, and projects where wall-dimmer control is required. A practical rule of thumb for LED strip sizing is to leave headroom rather than loading the driver to 100% continuously. Actual loading depends on strip wattage, run length, voltage drop, and installation conditions.

Installed in

Typically installed in millwork, commercial fit-outs, residential feature lighting, soffits, coves, display cabinets, and outdoor-rated low-voltage lighting systems. The enclosure style and magnetic construction are commonly selected where a hardwired remote driver is preferred over plug-in power supplies.

Why this product exists

This driver is built for 24V DC lighting systems that need higher wattage capacity with dimming support from a magnetic low-voltage control. Compared with smaller plug-in drivers, it supports larger connected loads and hardwired installations more suited to contractor and specification work.

Compared with similar products

Compared with electronic LED drivers, a magnetic driver is typically chosen when the lighting design or dimming method calls for magnetic low-voltage compatibility. This model is positioned as a 300W, 24V DC dimmable unit for indoor/outdoor use, with approximately 12.5A maximum output and a compact housing around 9.19 in x 3.94 in x 1.63 in (233 x 100 x 41 mm). Actual dimming performance depends on the dimmer, connected load, wiring layout, and fixture compatibility.

Specifications

• Manufacturer part number: EM300S24DC
• Brand: Axite Lighting
• Product type: Magnetic LED driver
• Input voltage: 120V AC, 60Hz
• Output voltage: 24V DC constant voltage
• Maximum output power: 300W
• Maximum output current: approximately 12.5A
• Dimming: Yes, magnetic dimmable
• Dimming range: 0-100% listed by distributor source
• Use location: Indoor / outdoor
• Enclosure rating: NEMA 3R / NEMA 4X references found across distributor listings; verify project requirement before ordering
• Operating temperature: -40 degC to 80 degC (-40 degF to 176 degF)
• Dimensions: 9.19 in x 3.94 in x 1.63 in (233.4 x 100 x 41.4 mm)
• Weight: 8.4 lb (3.8 kg)
• Warranty: 5 years
• Certification: cUL Listed reference found on distributor listing

Guidance only: connected load, dimming range, and voltage drop performance depend on the LED tape or fixture, run length, wiring method, and local electrical code.