What this product is for

This 24V DC magnetic LED driver is used to power compatible constant-voltage LED strip lighting and other low-voltage LED loads from a 120V AC supply. It is intended where phase-cut dimming is required and where a magnetic driver is preferred for compatibility with suitable dimming controls.

Use for

• 24V DC LED strip lighting
• Under-cabinet and cove lighting
• Accent and architectural lighting
• Indoor or outdoor low-voltage LED installations where a protected enclosure is suitable

Avoid for

• Constant-current LED fixtures
• 12V DC LED loads
• Loads exceeding 60W or 2.5A
• Installations using incompatible dimmers

Best for

Best for electricians and lighting contractors specifying 24V constant-voltage tape light or low-voltage LED systems that need dimming from a compatible magnetic low-voltage, ELV, or approved phase-cut dimmer. A common rule of thumb is to size the driver with spare capacity rather than loading it to 100% continuously.

Installed in

Typically installed in millwork lighting, display lighting, soffits, coves, under-cabinet runs, and exterior low-voltage lighting systems. The enclosure style and knockout entry suit hardwired installations by qualified trades.

Why this product exists

LED strip and other 24V DC lighting products require a stable low-voltage power source. This driver converts 120V AC input to 24V DC output and supports dimming with compatible controls, helping match line-voltage switching and dimming to low-voltage LED loads.

Compared with similar products

Compared with electronic LED drivers, a magnetic driver is commonly selected where magnetic phase-cut dimming compatibility is important. At 60W maximum output, this model suits shorter or moderate 24V lighting runs. Typical planning guidance is to size the connected load at approximately 80% of driver capacity for operating headroom; actual loading depends on fixture wattage, run length, ambient temperature, and dimmer behaviour.

Specifications

• Type: Magnetic dimmable constant-voltage LED driver
• Manufacturer part number: ML60S24DC
• Brand: Axite Lighting
• Input: 120V AC, 60 Hz
• Output: 24V DC
• Maximum wattage: 60W
• Maximum output current: 2.5A
• Dimming: Compatible phase-cut / magnetic low-voltage dimming with approved dimmers
• Enclosure: Black powder-coated steel
• Use location: Indoor / outdoor, enclosure rated NEMA 3R
• Lead wire rating: 18 AWG input and output leads
• Knockouts: 3/8 in trade size entry
• Approximate dimensions: 8.1 in x 3.9 in x 1.6 in (206 x 100 x 41 mm)
• Certification: Certified to CSA standard / UL 1310 referenced on source documents
• Temperature class: Class B, 130 degC
• Warranty: 5 years

Buying note: confirm the LED load is 24V constant-voltage and verify dimmer compatibility before ordering. Actual performance depends on installation conditions, insulation, layout, and local electrical code.